EN
WWW.BORMANNTOOLS.COM
3
People are forbidden to stand under the forks.
Do not move the hand stacker when the goods are lifted to the height more than 3m.
At other special condition or place, the operator should be carefully to operate the hand stacker.
Maintenance
Hydraulic OIL
Please check the oil level every six months.
Daily check and maintenance
It is necessary to check the hand stacker daily. Special attention should be paid to the wheels, the axles, as thread, rags, etc., which may block the wheels, the
fork and the mast should be checked, too. The forks should be unloaded and lowered in the lowest position when the job is over.
Lubrication
Use motor grease to lubricate all movable parts.
Remove the air
The air may enter the hydraulic pump during the transportation after the customer buys it. It will cause the piston rod to fail to keep up the raised height. The
air can be removed in the following way: pull the control handle up and move handle up and down for several times.
Οther Specifications
The fork descends without the release valve worked
•The impurities in the oil cause the release valve to be unable to close tight
•Some parts of hydraulic system is cracked or bored
•Air comes into the oil
•Sealing parts worn or damaged.
•Replace with new oil
•Inspect and replace the waste parts
•Banish the air
•Replace with a new one
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes signifi-
cantly affect the performance and safety of the products. The parts described / illustrated in the pages of the manual of the purchased product may also refer
to other models of the manufacturer’s product range, with similar features, other than the product you have purchased.
* Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is
used in commercial, trade or industrial businesses or for equivalent purposes.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and
special adjustments, must only be carried out by technicians of the authorized service department of the manufacturer.
