3
www.BormannTools.com
Safety Notes
•
Tip is hot. Do not touch.
•
Place the heated soldering gun on a heatproof work bench.
•
After finished using the soldering gun, cool the gun naturally.
•
Do not immerse in water!
•
Always rest the soldering gun on its end when not in use, i.
e. soldering
Gun
tip facing upwards.
•
If the cord is damaged, it must be replaced by the manufacturer or its
Service
agent or a similarly qualified person in order to avoid a hazard.
To prolong the life of the soldering gun and tip, it is recommended
That
you limit the switch
-
on position to a maximum of 1 minute, and
Allow
a break for minimum 4 minutes before the next
“
on
”
position, i.e.
Only
heat when actually soldering.
Operating Instruction
•
Check the voltage on the soldering gun is the same as source of
Current.
•
Make sure gun tip is in fixed position and screw is tightened.
•
Connect the tool to the mains current.
•
Surfaces of the connection points must be clean.
•
“
Tin
”
the tip by covering the heated tip with rosin core solder
•
Use the soldering gun to heat the connection points, not the solder.
•
Apply only enough solder.
•
Allow the joint to cool undisturbed
•
Clean the tip with a wet sponge while the tip is still heated.
•
Unplug the soldering gun and let the gun cool down naturally
