BorMann BPT1250, Manual, Page: 19 / 22

9
Figure 6
- The dust chute E is so positioned that both keys H are in line with the longitude holes G. Then push both
keys H into the longitude holes G. (refer to Fig. 6 )
E
Figure 7
DUST CHUTE CONNECTION WHEN THICKNESSING:
-Slide the fence to right side, and turn to 135
°
-Remove the blade guard K and place the dust chute E(See Figure 8).
-The dust chute E is so positioned that both keys H are in line with the longitude holes G. Then push both
keys H into the longitude holes G (See Figure 6).
The minimum air velocity at the extractor connection must be 20m/s(65ft/sec) to ensure an optimum
extraction.
Figure 8
SETTING OF GUARD
Height adjustment is made with the lever mounted on the left side of the machine. After lifting the lock lever
the blade cover can be slide ways to set the required stock width for jointing. Push lock lever down to lock
guard extrusion in position.
Refer to Figure 9. M
L
N
Figure 9
PLANING
The cutting depth is set by handle L at the front table plate N by means of the scale for cutting depth M.
Cutting depth between 0.5 and 1.5 mm (1/64~1/16 in.) will produce the best surface.
WARNING : The part of the cutter head not used has to be covered by the knife guard.
K
E
H