BorMann 045274, User Manual

Page: 12 / 156

EN
WWW.NIKOLAOUTOOLS.GR
12
Handling of dual voltage type generator
Operation of change over switch.
The circuit breaker on the control box must be used when application AC power, the air switch must be set at “OFF” position before
run the machine. After start the genset, the speed reach rated speed so turn the switch at “ON” position, so that the two sockets can
be used for output of rated voltage.
Set the main switch at “OFF” position when use 12 V power for charge.
The terminal of 12V output can be used for 12V voltage charge, user can provide a charge switch for switch on or switch off.
Fuel & engine oil already drained off before exit from factory
To check oil pipeline, and find whether there is air mixed into the pipeline, if yes, drain away the air from the pipeline before refuel and
start the diesel engine. The actual method is that, loosen the connection nut between injecting pump and pipeline and then drain off
the air until no air bubble from the fuel.
Inspection and operation of diesel engine
Low oil warning system/stop device.
The device works to stop the engine automatically when the oil pressure falls below the regulatory level and to prevent engine seizure
when lube oil is running short.
The oil temperature will rise too high if the engine is operated with insufficient lubrication oil. On the other hand , too much oil is
dangerous because the oil may combust and cause a sudden and excessive rise in engine rpm, so before operating the machine, be
sure to check the oil and supply oil to the specified level.
How to open the cabinet door and cover (diesel generator)
(1) Opening the cabinet door and raise the door and check daily.