EN
WWW.BORMANNTOOLS.COM
6
Lighting up the light (Pic. 5)
Pic.5: (1) Power switch
1. To light up the light, press down the power switch to the “ I ” position, then the light shines brightly (high mode); press down the power switch to the “II ”
position, then the light shines mildly (low mode).
2. To light off the light, press down the power switch to the “O (Middle)” position.
CAUTION: Do not look in the light or see the source of light directly.
Battery protection system
The tool is equipped with the protection system, which automatically cuts off the output power for long service life. The light goes off during operation when
the remaining battery capacity gets low. This is caused by the activation of the protection system and does not show trouble. Remove the battery cartridge
from the tool and charge it.
Adjusting the angle of the handle (Pic. 6)
Pic.6: (1) Hex bolts
Use hex wrench to loosen the hex bolts anticlockwise on the both side. Adjust the angle of the handle to the desired position .Then tighten the bolts clock
-
wise again.
Maintenance
CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance.
NOTICE: Never use gasoline, benzine, thinner, alcohol or the like. Discolouration, deformation or cracks may result.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Bormann PRO Authorized or Factory
Service Centers, always using Bormann PRO replacement parts.
Cleaning
From time to time wipe off the outside (tool body) of the tool using a cloth dampened in soapy water.
Summary of Contents for 036388
