BorMann 036333, Manual

Page: 5 / 18

EN
WWW.BORMANNTOOLS.COM
5
Safety instructions for battery cartridge
Use only the respective genuine BORMANN PRO batteries. The use of inappropriate batteries, or batteries that have been altered, may result
in the battery bursting causing fires, personal injury and damage. It will also void the warranty for the said BORMANN PRO tool and charger.
1. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion.
4. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. It may result in loss of your eyesight.
5. Do not short the battery cartridge:
(1) Do not touch the terminals with any conductive material.
(2) Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc.
(3) Do not expose battery cartridge to water or rain.
A battery short can cause a large current flow, overheating, possible burns and even a breakdown.
6. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50 °C (122 °F).
7. Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. The battery cartridge can explode in a fire.
8. Be careful not to drop or strike battery.
9. Do not use a damaged battery.
10. The contained lithium-ion batteries are subject to the Dangerous Goods Legislation requirements. For commercial transports e.g. by third parties, forward -
ing agents, special requirement on packaging and labeling must be observed. For preparation of the item being shipped, consulting an expert for hazardous
material is required. Please also observe possibly more detailed national regulations. Tape or mask off open contacts and pack up the battery in such a manner
that it cannot move around in the packaging.
11. Follow your local regulations relating to disposal of battery.
12. Use the batteries only with the appropriate
BORMANN PRO products. Installing the batteries to non-compliant products may result in a fire, excesssive
heat, explosion, or leak of electrolyte.
13. Save these instructions for future reference.
Tips for maintaining maximum battery life
1. Charge the battery cartridge before completely discharged. Always stop tool operation and charge the battery cartridge when you notice less tool power.
2. Never recharge a fully charged battery cartridge. Overcharging shortens the battery service life.
3. Charge the battery cartridge with room temperature at 5 °C - 45 °C. Let a hot battery cartridge cool down before charging it.
4. Charge the battery cartridge if you do not use it for a long period (more than six months).
Functional description
Always be sure that the tool is switched off and the battery cartridge
is removed before adjusting or checking function on the tool.
Installing or removing battery cartridge
Always switch off the tool before
installing or removing of the battery cartridge.
Hold the tool and the battery cartridge firmly when installing or removing
battery cartridge. Failure to hold the tool and the battery cartridge firmly may cause
them to slip off your hands and result in damage to the tool and battery cartridge and
a personal injury.
1. Button 2. Battery cartridge
To remove the battery cartridge, slide it from the tool while sliding
the button on the front of the cartridge. To install the battery car
-
tridge, align the tongue on the battery cartridge with the groove in
the housing and slip it into place. Insert it all the way until it locks in
place with a little click.
Always install the battery cartridge fully. If not, it may
accidentally fall out of the tool, causing injury to you or someone
around you.
Do not install the battery cartridge forcibly. If the
cartridge does not slide in easily, it is not being inserted correctly.