BorMann 032786, Manual

Page: 5 / 11

EN
WWW.BORMANNTOOLS.COM
5
WARNING : Check the status of the charger and battery before each charge. If there is
any indication of fault then do not continue, seek advice from an authorized vendor.
Battery pack efficiency and charging advice
Recharge the battery packs before they become completely exhausted. When you feel that the power of the tool becomes weaker, stop using the tool and
recharge the battery packs. If you continue to use the tool and exhaust the electric current, the battery pack may become damaged. Avoid recharging at high
temperatures. A rechargeable battery pack will be hot immediately after use. If such a battery pack is recharged immediately after use, its internal chemical
substance will deteriorate, and the battery life will be shortened. Leave the battery pack and recharge it after it has cooled for a while. The battery pack should
only be used and/or charged when battery pack temperature is,ideally, between 5
0
C and 30
0
C. The battery pack needs to be warmed-up or cooled down in
order to prevent damage to the batteries internal components should this temperature not apply at the time of recharging.
Note: Failure to warm up or cool down a battery pack could result in serious damage to either battery, charger, or even in injure for the user.
Assembly Instructions
Operation Instructions
Before using the tool, read the instructions manual carefully. The product is intended for light trimming of shrubs, grass and lawn edges in domestic use. Bear
in mind that there is a constant danger of being injured by the cutting blade, therefore at all cases, never start working with the shrub and grass shear without
wearing protective glasses and gloves. Check the working area for wires, rocks, broken glass that can possibly harm the blade, yourself or other people passing
by the working area. Danger! It is of outmost importance to always keep the tool away from hard objects.
A. Starting and Stopping (See Fig. IX )
Cutting grass with the grass shear ( Fig. X ):
1. Remove the protective cover of the blade (if one is provided).
2. Turning the appliance ON
A. Push the lock off button (2)
B. Push the button ON-OFF (4)
The appliance is now turned on and ready for cutting work.
3. Move the blade in a parallel manner with respect to the ground.
4. In order to make a closer cut slightly tilt the tool.
B. Cutting shrub with the shrub shear ( Fig. XI ):
1. Remove the protective cover of the blade (if one is provided).
2. Turning the appliance ON
A. Push the lock off button (2)
B. Push the button ON-OFF (4)
The appliance is now turned on and ready for cutting work.
3. Always move the blade in a parallel manner with respect to the shrub.
4. In order to make a closer cut slightly tilt the tool.
ACTION FIGURE
ASSEMBLY (Fitting/Changing the Blade)
1
Removing the blade
Warning: wear gloves!
Fig. I / II
2
Fitting the blade Fig. III / IV
Before Operation
3
Checking the battery
cartridge condition
Fig. V
4
Charging the
battery cartridge
Fig. VI
5
Installing the
battery cartridge
Fig. VII
6
Removing the
battery cartridge
Fig. VIII
Note :All necessary actions before operation are shown on the left
in a tabular manner. Each action is correlated with one or two
figures as presented in page 3 of this instructions manual.