BorMann 030577, Manual

Page: 5 / 10

EN
WWW.BORMANNTOOLS.COM
5
Switch Action
• Press and hold down the switch (5).
• To switch off, release the switch (5).
Continuous operation with engaged switch rocker
• Press and hold down the switch (5).
• To lock into position, hold down the locking button (6) and release the switch.
• To switch off, briefly press and release the switch (5).
Preselecting the speed
• To set the operating speed, move the speed dial (7) to the required value. Speed range from minimum RPM (position "1"), up to maximum RPM (position
"6").
Gears
NOTE . Do not loosen the screws (3) on the gear head during the warranty period. Non-compliance will deem the guarantee obligations of the manufacturer
null and void.
Changing the Velcro pad (Fig.3)
• Pull out the mains plug.
• Remove the polishing tool.
• Place machine on its back.
• Release and remove screw (2) with wrench (1).
• Remove worn Velcro pad (3).
• Remove contaminants from interior.
• Fit new Velcro pad and align securing holes.
• Insert screw (2) and tighten with wrench (1).
• Carry out test run. Check for imbalances and vibrations .
Functional instructions
CAUTION!
When the polisher is switched off, the polishing tool continues running briefly.
NOTE Following a tool change (e.g. wool pad instead of polishing sponge), the difference in weight may increase the vibrations. Change the operating speed
with the adjusting wheel (button) until the vibrations have been reduced.
• Switch on the machine before placing it on the surface which is to be polished and run the polisher up to the set speed.
• Applying light contact pressure, move the polisher in circular, overlapping movements on the surface which is to be polished in order to obtain a good
polishing finish and to ensure that the tool has a long service life.
• On sensitive surfaces (e.g. car paintwork) do not work aggressively but work at slow speeds applying low contact pressure.
• If using a polishing paste, use the respective tool for each paste.
Maintenance and Care
WARNING! Before carrying out any work on the polisher, always pull out the mains plug.
Cleaning
• Regularly clean the power tool and ventilation slots. Frequency of cleaning is dependent on the material and duration of use.
• Regularly blow out the housing interior and motor with dry compressed air.
Carbon brushes
NOTE
. Use only original parts supplied by the manufacturer for replacement purposes . If non-original parts are used, the guarantee obligations of the manu-
facturer will be deemed null and void. When the polisher is being used, the carbon brushes can be seen sparking through the rear air inlet apertures .
If the carbon brushes spark excessively , switch off the polisher immediately.
Take the polisher to a customer service workshop authorised by the manufacturer.
EN
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of
the products. The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line with similar features and may not be
included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and special adjustments, must only be carried out by
technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or even serious injury or death. The manufacturer and the importer
shall not be liable for injuries and damages resulting from the use of non-conforming equipment