BorMann 027607, User Manual, Page: 6 / 26

EN
WWW.BORMANNTOOLS.COM
6
Main Description
1. 1/4'' Hex. quick release collet
2. Variable speed trigger switch
3. Hand Grip
4. Led Worklight
5. 20V Li-ion Battery Pack
6. Belt Clip
7. Forward / Reverse selector
Basic Operation
Rotational Drive Selection (Fig.5)
The forward/reverse drive selector switch 7 determines the direction of rotation of drive (clockwise or anticlockwise).
To select the direction of rotation:
Stop machine and push the switch 7 to the left or right.
When the direction switch is pushed to the left, the chuck will rotate clockwise.
When the switch is pushed to the right, the drive rotate anti-clockwise.
Before operation, check that the switch is set the required position. Do not change the direction of rotation until the driver
comes to a complete stop.
When the driver is not in use move the switch to neutral (middle position) in order to lock the trigger.
Note: Failure to use the neutral position may activate the trigger inadvertently. This inadvertent operation may damage the
power tool.
Variable Speed Trigger (Fig.6)
When the trigger 2 is depressed the drive will rotate (provided the direction switch 7 is set in the forward or reverse position).
This trigger switch is electronic which enables the user to vary the speed continuously.
The speed varies according to how far the trigger switch is depressed.
The further it is depressed, the faster the drive spindle will rotate.
The lighter it depressed, the slower it will rotate.
Installing And Removing Bits (Fig.4)
This driver is supplied with a 1/4'' female hex.
1. Pull and hold the quick release collet 1 backwards to insert and to release the bit.
2. This product is equipped with an electric brake. Never use bits or accessories that are not hardened for impact use.
Belt Clip (Fig.7)
The spring steel belt clip 6 is convenient for hanging the drill temporarily. The clip can be installed on either side of the tool.
To install the clip:
Locate the clip 6 in position and fasten with screw 6.1 supplied, take care to not over-tighten and strip the thread.
LED Work-light (Fig.8)
To aid use in confined, and inadequately it spaces; the LED work-light 4 automatically illuminates when the trigger is
activated.
Disposal
At the end of the machine's working life or when it can no longer be repaired, ensure that it is disposed of according to
national regulations.
Contact your local authority for details of collection schemes in your area.
In all circumstances:
• DO not dispose Of power tools with domestic waste.
• DO not incinerate.
• Do not dispose of WEEE as unsorted municipal waste.