BorMann 022343, Manual, Page: 7 / 13

EN
WWW.BORMANNTOOLS.COM
7
2. Air flow adjustment:
The burners usually need no air flow adjustment.
If they should ever burn improperly, the air flow can be controlled by
adjusting the air damper inside the gas cooker(under the control knob).
After the gas has been ignited, adjust the air damper until slightly rounded, vigorous
blue flames appear (Fig. 17, 18, 19).
3. If the burner do not ignite at the same time:
This may be the result of air in the gas hose. Turn the gas control knob back to OFF
and fry again until the burner ignite.
4. To turn the burners off:
Turn the gas control knobs back to OFF position until you hear a click.
Make sure the burner is put out and turn off the main gas valve as well.
Care And Maintenance
Before you check and care for your gas cooker, make sure to turn off
the main gas valve, and wait for a period not to get burnt.
Check the gas hose regularly for wear or leaks. It must be replaced occasionally. Keep
it away from heater sources, and keep it clean.
Wipe the stainless steel top and body with a dry cloth.
if it is difficult to clean, use soapy water and then dry thoroughly with a dry cloth.
Wash the trivet in water dry thoroughly before replacing.
The electronic ignition will not function if it is wet. Be careful not to spill water, soup,
etc. On it (Fig. 20).
For better service and a longer service life, keep the gas cooker clean.
Warning: Do not wash the glass top in water when the top is hot.
Technical Data
Model / Burners:
1 - Burner 2 - Burner 3 - Burner 4 - Burner
Gas: L.P.Gas or N.G
Ignition System:
Electronic Ignition (PZT) or Pulse ignition
Hose: Φ 9.5 mm Rubber Hose
Rated Pressure (Pa): L.P.G: 2800 2800 2800 2800
N.G: 2000 2000 2000 2000
Thermal efficiency:
More than 65% More than 65% More than 65% More than 65%
Troubleshooting
Trouble Cause Remedy
It does not ignite. Main gas valve remains
closed.
Rubber hose is bent.
No gas supply.
Electronic ignition is wet.
Open it.
Put it right, or replace it.
Replace gas cylinder.
Clean and dry them.
Smell of gas Gas leak from pipe
Rubber hose is damaged.
Burner is not lit.
Examine pipe using soap
water, and replace it.
Replace it.
Re-i nite it.
Combustion is
Abnormal
Lack of gas supply.
Flame ports are clogged.
Burner is not in its correct
position.
Replace gas cylinder.
Clean them.
Place it right position.