BorMann 019039, Manual, Page: 5 / 17

5
www.BormannTools.com
Starting up
1. Attach air hose.
Device end (fig.4)
Place air hose end with pin in guide.
Secure by turning.
Spray gun end (fig.5)
Place the air hose firmly into the connection on the spray gun.
Any position can be chosen for connection.
2. Unscrew the container from the spray gun.
3. Adjust the ascending pipe accordingly.
It should be possible to spray the contents of the container leaving hardly any material left in the container
Spraying with horizontal objects (fig.7)
Turn ascending pipe A forwards.
Spraying overhead objects (fig.6)
Turn ascending pipe A to point backwards.
4. Fill container with coating material.
Screw firmly onto spray gun.
5. Place the spray gun in the spray gun holder.
6. Only place the device on an even and clean surfaces. Device could suck to dust, etc.
7. Before connecting to the mains ensure that the mains voltage corresponds with the details on the rating plate.
8. Remove the spray gun from the spray gun holder and point at object to be sprayed. Turn on using ON/OFF switch on the
device.
9. Adjust the spraying pattern and amount of material; set the amount of air and pressure, seefig.8, 9, 10.
10. Open trigger on the spray gun.
Note:
When the device is switch on the air will flow continually from the air cap
6
5. 6.
7.