General Safety
General Safety
- Always place the dispenser in its vertical position,
on a surface which can capably support its weight.
- During use this machine must remain in
its upright position.
- Adequate ventilation must be allowed for - we
recommend using the supplied ventilation ducting kit.
- Keep the machine away from sunlight, heat and moisture.
- The environment where this machine is installed must be
free of dust and corrosive/explosive gases.
Basic Troubleshooting
Problem/Report
Possible Cause
Suggested Action
No Water Dispensing
Water Pressure Regulator
Contact your distributor
No Sparkling Water -
If applicable
No CO2 pressure
Check CO2 bottle, regulator and non- return
valve. Supply pressure should be 58 psi (3.5-
4bar), replace as necessary
Carbonator Tank Not Filling
Contact your distributor
Poor Quality Carbonation -
If applicable
Air in Carbonator Tank
Isolate the power supply and operate the
sparkling water tap until gas is expelled. Allow
gas to expel for 5 seconds. Switch on power
supply and allow the tank to refill
Residue in Carbonator Tank
After prolonged use, a surface film can develop
within the carbonator tank. Refer to cleaning
and sanitising instructions
Carbonator Tank is Overfilled
If pump runs continuously, contact your
distributor
Warm Drinks
Insufficient cooling air flow through the fridge
Check that the ventilation kit has been installed
correctly.
Compressor not running
Contact your distributor
PCB not operating
Fridge failure
