EN
8
Safety
www.bora.com
DANGER!
Danger of electric shock!
The connection cable can be
damaged if it comes into contact
with hot cooking zones. A damaged
connection cable can cause a (fatal)
electrical shock.
X
Make sure that the connection
cable does not come into contact
with hot cooking surfaces.
X
Make sure that the connection
cable is not caught or damaged.
CAUTION!
Back injury caused by heavy loads!
When removing and inserting the
device, incorrect handling may cause
injuries to the limbs and the trunk.
X
Always lift the device out of the
packaging with two persons.
X
Always place the device onto
the worktop cut-out with two
persons.
X
Use suitable aids to prevent
damage to the limbs and the trunk.
X
Check the device for visible damages
before installing it.
X
Do not install a damaged device.
Q
Q
A damaged device may put your safety at
risk!
Repair and maintenance work may only be
carried out by specialists authorised by the
manufacturer.
Safety instructions, disassembly and
disposal
Disassembly of the device may only be carried
out by trained personnel who are familiar with
and comply with common national regulations
and supplementary regulations of the local
utility companies.
Work on electrical parts may only be carried
out by trained electrical personnel.
CAUTION!
Escaping hot liquids!
Unattended pans can boil over
allowing hot liquids to escape.
X
Always keep an eye on pans while
cooking.
X
Short cooking sessions must be
constantly monitored.
2.3 Safety instructions, assembly
Installation and assembly of the device may
only be carried out by trained personnel who
are familiar with and comply with common
national regulations and supplementary
regulations of the local utility companies.
Work on electrical parts must only be carried
out by trained electrical personnel.
The electrical safety of the device is only
guaranteed if it is connected to a properly
installed protective conductor system. Make
sure that these basic safety precautions have
been taken.
Cooktop
DANGER!
Danger of electric shock!
Connecting the device incorrectly
to the mains poses a risk of electric
shock.
X
Make sure that the device has a fixed
connection to the mains voltage.
X
Make sure that the device is
connected to a properly installed
protective conductor system.
X
Make sure that technical
equipment is provided to allow for
all of the device’s poles to be
disconnected from the mains with
a contact opening width of at least
3 mm (miniature and automatic
circuit breakers, fuses, contactors).
