bora PKCH2, Operating And Instalation Instructions

Page: 20 / 36

EN
20
Installation
www.bora.com
X X
Rotate the cooktop 180°.
X X
For the installation, proceed as described above.
X X
Change the installation direction in the configuration
menu (see Configuration menu).
INFO If installation is rotated by 180°, then the
connections for the control knobs and the
extraction system are at the rear.
INFO Cables of sufficient length are provided.
5.5.4 Sealing the cooktop
X X
Make sure that no silicone sealant gets under the
cooktop.
1
Fig. 5.16 Silicone sealant for flush installation
[1]
black, heat-resistant silicone sealant
1
Fig. 5.17 Silicone sealant for surface mounting
[1]
black, heat-resistant silicone sealant
5.5.5 Establishing communication
The appliance components are linked by the ribbon cable
provided.
X X
Create the connection between the cooktop and the
control knobs.
X X
Create the connection between the cooktop and the
cooktop extractor.
1
3
2
Fig. 5.14 Mounting brackets
[1]
Mounting bracket
[2]
Washer
[3]
Screw
X X
Fasten the cooktop using the mounting brackets [1].
X X
Tighten the mounting brackets with the screw [3] using
the washer [2] with max. 2 Nm.
X X
Verify that the alignment is correct.
X X
Once all of the installation work is complete, seal the
devices with black, heat-resistant silicone sealant.
5.5.3 Installation rotated by 180°
1
3
2
Fig. 5.15 Minimum clearances for installation rotated by 180°
[1]
Minimum clearance of 70 mm at the back from the worktop
cut-out to the rear edge of the worktop.
[2]
Minimum clearance of 300 mm from the left and right of the
worktop cut-out to the adjacent cabinet or wall.
[3]
Minimum clearance of 600 mm between the worktop and
the wall unit.