EN
17
Installation
www.bora.com
5.6 Power connection
X
X
Observe all safety and warning information see the
chapter safety.
X
X
Observe all national and regional laws and regulations
as well as the supplementary regulations of the local
utility companies.
INFO
The power connection must only be imple-
mented by a certified engineer. He/she also
assumes responsibility for the proper installa-
tion and commissioning.
The power supply line for use (pre-assembled) must be at
least Type H05VV-F or H05VVH2-F.
Q
Q
Cross-section: 3G1,5 mm²
Q
Q
If the supply line is damaged, it must be replaced by a
specific one. This must be done by an authorized Cus-
tomer Service agent.
Establishing the power connection
X
X
Switch off the main switch/automatic circuit breaker
before connecting the cooktop.
X
X
Protect the main switch/automatic circuit breaker
from being switched on without permission.
X
X
Make sure the device is not energised.
X
X
Connect the power cable.
X
X
Connect the cooktop directly through a fixed connec-
tion to a power supply line.
1
L1
2
N
PE
220 - 240 V~
Fig. 5.12 Single-phase wiring diagram
X
X
Verify that the installation was done correctly.
X
X
Switch on the main switch/automatic circuit breaker.
X
X
Put the cooktop extractor into operation (see the
Operation chapter).
X
X
Check all the functions are working correctly.
5.7 Handover to user
Once installation is done:
X
X
Explain the important functions to the user.
X
X
Explain all safety-relevant aspects of operation and
handling to the user.
X
X
Provide the user with the accessories and operating
and installation instructions to be kept in a safe place.
X
X
Align the cooktop [1] exactly.
X
X
Adjust the installation height of the cooktop with the
height compensation plates, if necessary.
1
2
Fig. 5.10 Cooktop and height compensation plates
[1]
Cooktop
[2]
Height compensation plates
For surface installation
X
X
Make sure that the sealing tape of the cooktop is res-
ting on the worktop.
For flush installation
X
X
Make sure that the sealing tape of the cooktop is
sealed well all the way round.
2
1
Fig. 5.11 Mounting brackets
[1]
Screw
[2]
Mounting bracket
X
X
Fasten the cooktop [1] using the mounting bra-
ckets [2].
X
X
Tighten the mounting bracket screws [1] with max.
10 Nm.
X
X
Verify that the alignment is correct.
X
X
Seal the devices with black heat-resistant silicone
sealing compound after the installation work is com-
pleted.
Summary of Contents for CCH1
Page 25: ...EN 25 Notes www bora com EN 11 Notes...
Page 26: ...EN 26 Notes www bora com...
Page 27: ......
