10
DMX control
Connect the fog machine to your DMX-controller, using standard XLR male to XLR female
cables. Select the correct DMX starting address by using the dipswitch panel just above
the XLR-connectors. A status LED is provided, indicating that the machine receives
DMX-signal from your controller.
Turning on the machine
Turn on the ON/OFF switch on the rear of the machine. When
doing so, you will not have instant smoke as the internal heating element needs to reach
a certain temperature. The machine has a built-in indication LED, which projects on the
liquid tank. This way you can see the tank light up when the fog machine is ready
(indicated with a blue LED). Also the wired timer remote shows a ‘ready’ indication, with
a green LED.
Projecting fog
After +/- 45 seconds (depends on the output volume) the fog machine will
stop its output to reheat the internal heating element. A built-in thermostat keeps the
heating element on a proper temperature. During the reheating time, the fog machine
cannot be used to project any fog.
TECHNICAL SPECIFICATIONS
1000 Watt heater
Time and ration control fogger
Warm Up Time:10 min
Control: DMX-512 or supplied remote
1 litre removable fog fluid tank
Fog output: 15,000 cu. ft. per minute
Power Supply:AC110V/230V
50-60Hz
Power Consumption:1500W
Dimensions: L570
x W208 x H320mm
Weight: 7.65Kg