Boomerang® E-155 Chorus*Delay – Software Version 1.1 – 7 Nov 2011 – Page
8
NOTE
- The E-155 will function differently depending on which jacks are used. The following table lists all valid connections.
“X” means a cable is plugged in.
“—“ means there is no cable connected.
Input
Output
L
R
L
R
Behavior
—
X
X
—
Mono in, mono out
X
—
X
—
Mono in, mono out
X
—
X
X
Mono in, stereo out
—
X
X
X
AirMix™ Output - Mono in, effect out L, dry out R
X
X
X
—
Stereo in, mono out
X
X
X
X
Stereo in, stereo out
Pedal Link™ Connectors
These are for linking two or more Boomerang® effects pedals to create an effects system or using an external MIDI
controller to recall presets.
Expression Pedal Jack
Connect your expression pedal here using a stereo cable with a ¼” TRS phone plug.
11. Do’s, Don’ts & Other Suggestions
•
Don’t assign any knob to be controlled by an expression pedal if you don’t have an expression pedal attached. You might
not like the resulting behavior.
•
Don’t connect the output of a power amplifier to this or any pedal.
•
IMPORTANT
– Do power your rig up and down correctly. When you power up any amplified system, turn the power amp
on last. Plug everything together, turn on all effects and then turn on your amp. When powering down, turn your amp off
first. This will avoid annoying pops & clicks.
•
Do experiment freely, even wildly.
•
Do contact us if you have any comments or questions about any of our products.
12. Problems
Problem
Solution
There is no delay or chorus
effect when you recall a preset.
The preset might have been stored with both effects turned off. Press the chorus &
delay on/off buttons.
There is no delay or chorus
effect when you recall a preset
and the effects are turned on.
1) The Delay Level, Chorus Mix or Chorus Depth knob was setup to be controlled by an
expression pedal and no pedal is connected. See “Individual Parameter Control –
Turning It Off” above.
2) An expression pedal is connected and set to control effect level but is in the
minimum position; move the expression pedal.
No sound comes through the
pedal.
1) Move the amp connection to the left output jack. The right output jack will not work
with only one input.
2) Reverse Delay is being used and the level is set to 11. Set the level to 8 or lower.
The Chorus and Delay Style
lights and/or the on/off lights
are blinking.
Press & hold both the Chorus and Delay Style buttons for 2 seconds.
The clock display doesn’t
move when I turn a knob.
That knob is controlled by the expression pedal. See “Individual Parameter Control –
Setting It Up”.
