15
ProBLeM CauSe SoLution
Machine does not operate.
Faulty power cord.
Contact Service Center.
Tripped circuit breaker.
Reset circuit breaker on machine.
Tripped building circuit breaker.
Reset circuit breaker in building.
Faulty machine wiring.
Contact Service Center.
Faulty On/Off handle switch.
Contact Service Center.
Faulty motor.
Contact Service Center.
Rectifier burned out.
Contact Service Center.
Machine operates with a wobble
or jerky motion.
Soiled Pad.
Replace Pad.
Improper pad/brush for application.
Change to proper pad/brush.
Pad driver/brush not installed correctly.
Remove and reinstall pad driver/brush.
Pad/brush unevenly worn.
Replace pad/brush.
Pad not properly centered on pad driver.
Remove and reinstall pad.
Machine circuit breaker trips
continuously.
Heavily soiled pad/brush.
Clean or replace pad/brush.
Improper pad/brush for application.
Change to proper pad/brush.
Defective circuit breaker.
Contact Service Center.
Worn carbon brushes in motor.
Contact Service Center.
troubleshooting
Warning: Motor will become hot
to the touch
This custom motor has a large amount of windings in a
relatively small package to reduce weight. Your motor will
get very hot to the touch. This is normal. This should not
exceed 310 degree Fahrenheit.
To operate the push lock fittings
push
the tubing into the fitting while at the same time push the
green bushing into the fitting. Continue to hold the green
bushing into the fitting and then pull out the tubing. This
may take a little practice but will become easy after several
tries.
Bushing
Tubing