-35-
CLEANING
OUTER CLEANING
For a good preservation of the cabinet’s body
a periodical cleaning is necessary
.
EXTERNAL BODY
: When necessary, the external body should be cleaned with a cloth and a neutral soap
and water solution.
STAINLESS STEEL SURFACES
: Wash with warm water and mild detergent, rinse well and dry with soft cloth.
Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL
: Wash with warm water and mild detergent, rinse well and dry with soft
cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES
: Only use products specifically designed for glass cleaning; It is not advisable to use
ordinary water which can leave a film of calcium on the surface of the glass.
1
2
3
4
INNER CLEANING
By tank cleaning, proceed as follows:
1. Place the goods in special refrigerated containers, kept at the same temperature and remove the shelves
2. Unplug the unit.
3. Leave the doors open and begin the operation of tank washing when the tank temperature is the same as
the ambient temperature.
4. Clean and dry the interior of the tank with a soft cloth, using neutral soap.
5. Then plug the unit and wait till the appliance reaches the right temperature before filling it again.
Do not
use jet of water to clean the cabinet: electrical wiring could be damaged.
Never use mechanical devices or any other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
WATER COLLECTION TANK CLEANING
Attention!
Clean based on use and need and in particular
environmental conditions (e.g. high humidity, low room
temperature, presence of dust, etc.) to avoid incorrect
and incomplete evaporation of water and/or presence
of unpleasant odours.
PROLONGED SWITCH OFF
Se la macchina dovesse rimanere inattiva per un certo tempo occorre effettuare le seguenti operazioni:
•
Unplug the unit;
•
Clean and dry the tank well;
•
Cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric agents.
