5. Specifications
Model No
TB-1175
Heater out put
175W
Heater voltage
100V
Iron tip
BK7 series / BK11 series
Heater element
Alumina Ceramic
Leak voltage
≦
2.0mV (Initial value)
Ground resistance
≦
2.0
Ω
(Initial value)
Cord
EP rubber cord : 1.2m
6. Trouble shooting & Guarantee
(A) Trouble shooting
Phenomena
Confirmation points
Measures
Iron tip is not heated
①
The iron unit and the controller are connected properly.
Lock the connector of iron unit.
②
The heater element is consumed. (check the conduction)
Exchange heater element
Abnormal indication of
temperature
(rapid-rise / error etc. )
①
Deterioration or Open of sensor wire at the iron tip
Exchange iron tip
②
The iron tip and the iron unit are connected properly.
Fasten the iron tip to iron unit
with lock-wire.
(B) Guarantee
Our products are shipped after several factory test & inspection. However, if you find malfunctions or defects in
workmanship or transportation, please contact with your dealer or us.
The guarantee period is one year after your purchase, except for replacement parts.
(C) After-Sales Service
In case the products you purchased do not operate properly, read this manual again.
If the troubles are still not resolved, please contact with your dealer or us.
7. Set-up the controller sensor type
The sensor type of this soldering iron is
[K-type]
. When connecting to the Patriot controller, please make sure the
sensor type of controller is also
[K-type]
.
*** HOW TO SET /CHANGE THE SENSOR TYPE ***
e.g. M12 Controller ( For other controllers, please refer to each manual attached when purchased.)
Ⅰ：
At the operation mode, press
key for approx. 3 seconds with pressing
▽
key.
is indicated at PV screen.
Ⅱ：
In order to set
[K-type]
, indicate
at SV screen by pushing
△
key and
▽
key .
Push
key 7-times to return to the operation mode again.
Operation mode
⇒
⇒
⇒
⇒
Set Up mode
⇒
⇒
⇒
⇒
Set Up mode
⇒
⇒
⇒
⇒
Operation mode
Japan Bonkote Co., Ltd.
☏
☏
☏
☏
+81-29-241-2725
✉
✉
✉
✉
