BOND MANUFACTURING HYPH4601-4 Owner'S Manual Download Page 3

3

  Never store propane near high heat, open 
flames, pilot lights, direct sunlight, other ig

-

nition sources or where te

m

peratures ex

-

ceed 120  (49

 

).

  Propane is hea

vier than air and can accumu-

late in low places. If you sme

ll

 gas, leave the

area immediately.
  Never install or remove propane cylinder 
while heater is lighted, near flame, pilot light, 
ignition sources or while heater is hot touch.
  

This heater is red hot during use and can ig-

nite flammables too close to the heater. Keep 
flammables at least 2 feet from sides & 2 feet 
from top. 

Keep gasoline and other flammable 

liquids and vapors well away from heater.
  The propane cylinder must always be stored 
outdoors in a well ventilated space. Never 
store propane cylinder in an enclosed 
area(house, garage, etc.).

 If heater is to be 

stored indoors, disconnect the propane cylin-
der for outdoor storage.

C

A

R

B

ON 

M

ONO

X

IDE H

A

Z

A

RD

  This heater is a combustion appliance. All 
combustion appliances produce carbon 
monoxide(CO) during the combustion process. 
This product is designed to produce extr

e

mely

minute, non-hazardous amount

s

 of CO if used 

and maintained in accordance with all 
warnings and instructions. Do not block air 
flow into or out of the heater.
  Carbon monoxide(CO) poisoning produces 
flu-like symptoms, watery eyes, headaches, 
dizziness, fatigue and possibly death. You 
can’t see it and you can’t sme

ll

 it. It’s an in-

visible killer. If these symptoms are present 
during operation of this product get fresh air 
immediately.
  For outdoor use only.
  Never use inside 

house, or other unventil-

ated or e

nclosed areas.

  This heater consumes air(oxygen). Do not 
use in unventilated or enclosed areas to avoid 
endangering your life.

SER

V

ICE S

A

F

E

TY

  Keep all connections and fittings clean. Make 
sure propane cylinder valve outlet is clean.
  Inspect hose before use. Replace if there is 
evidence of abrasion or wear.
  During set up, check all connections and 
fittings for leaks using soapy water. Never use 
a flame.
  Use as a heating  appliance only. Never alter 
in any way or use with any device.
  Check entire hose at least annually.

B

URN H

A

Z

A

RD

  Never leave heater unattended when hot or 
in use.
  Keep out of reach of children.

The maximum gas supply pressure is 250psi.

Don’t store certain materials such as cloth, 

plastic products ect. under the heater, 

or it 

will be subjected to radiant heat and could 
be seri-ously damaged.

Do 

an 

inspection of the visib

l

e portion of the 

hose before each use of the appliance. If the 
hose is damaged

, the replacement hose 

assembly shall be that specified by the 
manufacturer. 

Do the l

ight

ing

 

of 

the heater accroding 

to 

the lighting instruction

s

, otherwise may 

cause injury or property damage.

 Do not use 30 lb propane cylinder for this 

appliance.

Summary of Contents for HYPH4601-4














Reviews: