TIPS:
Before Beginning
●
Read the instructions thoroughly.
●
For future reference, save this owner's manual.
Before each use, inspect all parts.
*After assembling the gas tank, push and turn the Control Knob counter-clockwise, then use a match or a lighter to light
the fireblow. To adjust the flame, turn the Control Knob. Push and turn the Control Knob clockwise to turn the flame off.
Caution:
*If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite
with risk of injury.
●
Check and make sure that all parts are present.
TO LIGHT
STEP 4.
(I)Make sure the gas valve is turned "OFF" before
assembling. Check each part before using the product. To
set the gas tank in the firebowl, screw it to the regulator
inlet fitting inside the firebowl.
See Figure I.
(II) Place the lave rocks on the burner averagely. See
Figure II and III.
(III) After assembling the gas tank, push and turn the
Control Knob counter-clockwise, then use a match or a
lighter to light the firebowl. To adjust the flame, turn
the Control Knob. Push and turn the Control Knob
clockwise to turn the flame off. See Figure I and III.
STEP 4. LEAK TEST
Perform leak test in a well ventilated area outside and where no source of spark can occur.
Connect cylinder to regulator. Turn the on/off valve at the unit to the ‘off’ position to pressurize the control system. Use a soapy
water solution to check all the connections leaks before attempting to light the appliance.
If a leak is found or you smell gas,
disconnect cylinder and turn valve off and do not use the appliance until repairs can be made.
４
