20- Decor
Note: Glue the Right and Left gear
door on to the fuselage only. Do
not glue them to the cowl if you
want to remove the cowl out of the fuselage.
Nose Gear door installation
Gear door (3mm plywood)
Do not
glue here.
CA
WING
5x25mm screw
5X25mm screw
......2
......2
19- Installation the wing
Secure the wing in place using
the 5x25mm screw.
CA
Sticker
Sticker
Sticker
Sticker
Note: Cut out the stickers and apply them in the proper area. Do not peel the backing paper off all at once.
Peel off one corner of the backing and cut off with scissors.
Arrange sticker on model and when satisfied adhere the corner without backing.
Carefully peel back the rest of the backing while at the same time adhering the rest of the sticker.
Try not to make air bubbles, if there are some, carefully puncture sticker (center of bubble) but not model surface with
the tip of the knife or sharp pin and squeeze out the air.
At curves stretch sticker and apply a little heat so that no ceases occur.
Cut off the excess that is produced.
