16
4430 Gibsonia Rd. • Gibsonia, PA 15044 • USA • www.bontool.com
B L A D E S A R E E X T R E M E LY S H A R P.
CONTACT WITH THE BLADE CAN RESULT
I N P R O P E R T Y D A M A G E A N D / O R
P E R S O N A L I N J U RY. B L A D E S A R E
PROVIDED WITH A PROTECTIVE COVER
OVER THE CUTTING EDGE. EXERCISE
EXTREME CAUTION WHEN REMOVING
AND/OR REINSTALLING THE PROTECTIVE
C O V E R . S T O R E T H E B L A D E W I T H T H E
P R O T E C T I V E C O V E R P R O P E R LY
I N S TA L L E D T O M I N I M I Z E T H E P O T E N T I A L
FOR BLADE DAMAGE AND/OR PERSONAL
INJURY.
8) Return the Bon Floor Stripper to its normal operat-
ing position.
9) Determine that the ON/OFF switch located on the
operator handle is in the OFF position. If the Bon
Floor Stripper is to be used immediately, then recon-
nect the extension cord or Bon Floor Stripper to the
power source.
UNEXPECTED MACHINE START UP CAN
RESULT IN PROPERTY DAMAGE AND/OR
PERSONAL INJURY.
REMOVING THE BLADE OR CERAMIC TILE
RIPPER ATTACHMENT FROM THE Bon
Floor Stripper.
Tools Required: 1 each, 5/32 inch T-handled Allen
wrench provided with the machine.
WHEN INSTALLING OR REMOVING A
BLADE
O R T H E C E R A M I C T I L E R I P P E R
A T T A C H M E N T T O / F R O M T H E B O N
F L O O O R S T R I P P E R , A L W A Y S W E A R
T H E A P P R O P R I A T E S A F E T Y E Y E -
W E A R , GLOVES, LEATHER SHOES AND
LONG PA N T S T O M A X I M I Z E P E R S O N A L
PROTECTION FROM THE SHARP EDGE(S).
IMPROPER CONTACT WITH A SHARP EDGE
CAN RESULT IN PROPERTY DAMAGE
AND/OR PERSONAL INJURY.
1) Properly disconnect the extension cord or the Bon
Floor Stripper from the power source.
2) To place the operator handle in the work position,
move the handle upright so that the ball-detent pins
can be inserted through the operator handle and main
frame. Determine the ball-detent pins are inserted
through the operator handle and main frame to fully
expose the ball detent. FIGURE 15
FIGURE 15
T H E B A L L D E T E N T M U S T B E F U L LY
EXPOSED AGAINST THE MAIN FRAME TO
PROVIDE THE PROPER PIN RETAINING
FORCE. AN IMPROPER PIN RETAINING
C O N F I G U R AT I O N C A N R E S U LT I N
U N E X P E C T E D O P E R AT O R H A N D L E
M O V E M E N T. T H I S O C C U R R E N C E C A N
RESULT IN PROPERTY DAMAGE AND/OR
PERSONAL INJURY.
3) Loosen the threaded handle knobs and extend the
operator handle out until it stops against the threaded
studs. Retighten the knobs. FIGURE 16.