2. Position your rebar to desired length and then exert
enough downward pressure on the handle
(
key
#8).
Unit is equipped with 3/4" opening
which will cut up to 5/8" rebar.
1. Line up the bending arm to its lowest
position so that cutter-bushings
(key #13) are in cutting position.
CUTTING INSTRUCTIONS
For more information, contact your nearest
Bon Tool Co. authorized distributor or
Bon Tool Co. at 724-443-7080
ALWAYS WEAR SAFETY GLASSES WHEN OPERATING
UNIT TO AVOID INJURY.
1. Line up the bending arm so that it is in its lowest
position (parallel to the roller (
key
#11)), and then
slide the rebar on the roller and into the bending
arm.
3. While standing on the
board (
key
#9) exert
sufficient downward
pressure on the
handle (
key
#8) to cut
the rebar.
3. In order to make tighter bends remove handle from
one socket and position in another socket and
continue to bend rebar.
BENDING INSTRUCTIONS
SAFETY INSTRUCTIONS
• Always operate unit on a solid, level area
• Make sure that nuts and bolts are tight and secure before using
• Operator should have solid footing when using the rebar cutter/bender, once
rebar is cut pressure is suddenly released
• Always wear eye protection when operating unit
ALWAYS WEAR SAFETY GLASSES WHEN OPERATING
MAINTENANCE
• Unit should be greased everyday when in use, using the grease fitting (
key
#10)
• After use unit should be cleaned of all debris
• Disassemble as often as necessary to clean and repack the bearing set (
key
#7)
with grease
• Replace broken or badly worn parts as soon as possible to keep unit in good
working condition. Call (724) 443-7080 for replacement parts.
• If cutter-bushings (
key
#13) become chipped or dulled change cutting side of
the cutter-bushing by removing and flipping cutting edge to other side.
REBAR CUTTER/BENDER COMES WITH A ONE YEAR WARRANTY ON
PARTS AND WORKMANSHIP. WARRANTY IS VOID IF ATTEMPTING TO
CUT NO GRADE REBAR, OR OTHER MATERIALS IN WHICH UNIT IS
NOT INTENDED
2
2. Insert the rebar through the cutting
hole in the hub w/bushing to the
desired length (add two inches from
the back plate (key #4) for actual
cutting length).
NOTE: BE SURE NOT TO CUT
NO GRADE REBAR WITH THIS
CUTTER AS THIS WILL VOID
WARRANTY.
IS12359 05/18
PAGE 2 OF 2
Bon Tool Co. • 4430 Gibsonia Rd. • Gibsonia, PA 15044 • USA • www.bontool.com
