33
31) Deck Drain
It provides drainage of water from rain,
deck washing, water splashing, etc.
Keep clean to avoid clogging.
TYPICAL
1. Driver‘s seat
2. Deck drain
32) Oil Injection Tank Cap
The cap is located under the rear stor-
age compartment cover on port side.
1. Oil injection tank cap
Unscrew cap by turning counterclock-
wise and firmly tighten by turning
clockwise. Close cover. Refer to FUEL
AND LUBRICATION for injection oil
specification.
33) Flushing Connectors
Refer to POST-OPERATION CARE sec-
tion for proper use.
NOTE:
Each engine is provided with a
flushing connector onto jet pump sup-
port. Port connector is for port engine
and starboard connector is for star-
board engine.
For your convenience, there are addi-
tional flushing connectors under the
rear storage compartment cover. Lift
cover, the flushing connectors are on
each side of the storage compartment.
1. Flushing connector with its cap
You may use the flushing connectors
at the location that you find more prac-
tical.
NOTE:
When using upper flushing con-
nectors, hose pincher(s) must be in-
stalled in engine compartment. this will
avoid water from going out directly by
the flushing connector on the jet pump.
Refer to POST-OPERATION CARE sec-
tion.
34) Ventilation Ducts
This is where air flows to supply engine
and ventilate engine compartment.
They should never be obstructed.
WARNING
Add oil to level mark. Do not over-
fill. Reinstall cap and fully tighten.
F04L98Y
2
1
F04E1BZ
1
F04E1AY
1
lmo2002_003a.book Page 33 Wednesday, November 14, 2001 2:39 PM
