PAGE 2 OF 3
415 0102 00
PREPARATION
Tools Required
Measuring tape
Drill
6.5 mm (1/4 in) drill bit
Robertson screwdriver
no. 3
(black, square tip)
10 mm (3/8 in) and 11 mm (7/16 in) wrenches
or sockets with 30 mm (12 in) extension and
ratchet.
INSTALLATION
Remove seat from vehicle.
Lean rail
no. 1
on tunnel so that the back of the
steel angle is flush with edge of tunnel.
1. Slide of rail higher than tunnel
2. Flush with edge of tunnel
Install rail so that the slots align with those that
are on the tunnel.
Hold rail firmly and using a punch, mark the slots
on the tunnel for drilling references.
Using rail as a template, drill holes in frame with a
6.5 mm (1/4 in) drill bit.
CAUTION : When drilling, align the drill
bit in the center of the slot and at the outer
edge to allow proper adjustment.
WARNING : Be careful not to drill heat ex-
changers underneath frame.
Install rail with mounting hardware
no. 7
. Insert
bolts from top and then washers and nuts from
beneath.
NOTE :
Wood screws from the mounting
hardware bag will be used later in the instal-
lation.
Use the ratchet and extension for easy access be-
neath the tunnel. Tighten the nuts loosely for now.
Repeat procedure for the other side using left
hand rail
no. 2
.
Reinstall seat (do not tighten) to adjust the rail dis-
tance accordingly.
Insert the sliding plates
no. 3
into the rails, the
backrest frame
no. 4
onto rails and install the ad-
justable knobs
no. 6
. Tighten knobs loosely.
Slide the backrest frame forward and back to as-
sure the rails are parallel and that the frame move-
ment is unobstructed.
Remove seat and tighten the bolts on each rail.
Slide the backrest frame forward and back again
to assure easy movement.
IMPORTANT:
Adjust backrest width prior to in-
stalling cushion.
NOTE :
If the luggage rack and the backrest
are to be installed at the same time, proceed
with rack installation before installing cushion.
Position the cushion
no. 5
on the backrest frame
so that it is centered both from side to side and
top to bottom.
NOTE :
Make sure to keep at least 16 mm(5/
8 in) on top so that if a luggage rack is in-
stalled, the top of the cushion will be flush with
the top of the racks transverse bar.
Secure cushion with wood screws
no. 7
.
Apply a light coat of grease on sliding surface of
rails.
Adjust backrest to desired position and tighten ad-
justement knobs.
Reinstall seat.
WARNING : Periodically check the adjust-
ment knobs to assure that they are tight.
A01H0XA
1
2
-
;
'
'
'
;
