16
09/2013
Cleaning the Water Inlet Filter
The inlet filter should be cleaned every 1 - 3 months.
- Close the tap.
- Unscrew the water inlet hose.
- Clean the filter with a small brush.
- Install the water inlet hose firmly again, open the tap and make sure that no water drips from the
hose.
Cleaning the Drain Pump Filter, remove foreign bodies
The foreign body trap in the drain pump prevents that rinsed parts blocks the drain pump system.
Clean the trap periodically to ensure the normal operation of washing machine.
Check the foreign body trap if the water in the wash cycle will not drain or increased noise can be
heard during the pumping.
If the drain pump is clogged, substantial quantity of water could be in the machine (max. 25l).
First, drain the water and then open the trap to clean away foreign bodies.
CAUTION
: Burn hazard if washing at high temperature has made shortly. Take care if the drained
water is hot.
Disconnect the machine the
Position a basin or other recipient Loosen the filter at left only
from the mains electricity
between the cabinet and filter spill just enough to drain the
supply. Insert a coin or others lip.
water.
Don´t pull out the
into the open slot flip side.
filter completely!
4. Stop the water flow by turning the filter at right.
5. When the water is drained off, pull out the filter completely
6. Clean the filter.
6. Reattach the filter and look for a tight fit so that no water can escape. Close the bottom cover plate.
ATTENTION:
Never operate the appliance without filter.
Cold conditions
If the machine is exposed to temperatures below 0°C, certain precautions should be taken.
- Turn off the water tap.
- Unscrew the inlet hose.
- Unhook the drain hose from the rear support and position the end of this hose and that of the inlet
hose in a bowl. Run the spin programme.
- Disconnect the appliance.
- Screw the inlet hose and reposition the drain hose.
- When you intend to start the machine up again, make sure that the room temperature is above
0°C.