BOMANN KSG 235, Instruction Manual

Page: 16 / 24

16
Electrical connection
Electrical connection Electrical connection
Electrical connection
WARNING:
WARNING: WARNING:
WARNING:
•
The installation to the mains supply must conform
to the local standards and regulations.
•
Improper connection may cause to an electric electric electric electric
shock shock shock shock!
•
Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
•
The accessibility of the power plug must be en-
sured in order to disconnect the appliance from
the power supply in case of an emergency.
CAUTION
CAUTION CAUTION
CAUTION::::
In case of disconnection or power failure:
-
wait for approx. 5 minutes before restarting;
-
check the operation settings.
•
Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
•
Connect the mains cable to a properly installed
and earthed wall outlet.
Reverse the Door Opening
Reverse the Door Opening Reverse the Door Opening
Reverse the Door Opening
If required, the door opening can be moved from the
right (delivery condition) to the left side.
WARNING: WARNING: WARNING: WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply. Always unplug
the appliance first.
NOTE NOTE NOTE NOTE::::
•
When installing, ask another person to assist.
•
You possibly need:
screw wrench, Phillips screw-
driver as well as a thin-blade screwdriver.
•
Remove the cover (a) of the upper door hinge (b)
and dismount it by loosening the screws under-
neath.
•
Open the appliance door a little and take it care-
fully of the lower door hinge. Place the door on a
padded surface to prevent it from scratches.
•
Move the cap (c) to the opposite holes.
•
Tilt the appliance slightly backwards and block it
in this position. Unscrew the feet. Dismount the
lower door hinge (d) and the holding device (e) by
loosening the screws.
•
Rotate the hinge (d) and the holding device (e)
about 180° and replace the items after you have
unscrewed the hinge pin and used by the other
hinge side. Tighten all screws and turn in the feet
accordingly.
•
Replace the appliance upright again. Insert the
appliance door on the lower hinge pin and fix the
door to the property position.
•
Transfer the upper door hinge (b) accordingly. Put
the hinge pin in the hole of the appliance door
and
tight the hinge. Put on the hinge cover (a) again.
•
Check if the door is arranged vertical as well as
horizontal, so that a smooth opening and closing
of the door is ensured.
•
Dismount the door handle and attach it to the
corresponding other door outer side. Refer to the
instructions in "Assembling the door handle".
Startup / Operation
Startup / Operation Startup / Operation
Startup / Operation
Prior to first use Prior to first use Prior to first use Prior to first use
CAUTION CAUTION CAUTION CAUTION::::
After transport, the appliance should be left standing
upright for about 4 hours before connecting to the
power supply. Nonobservance could lead to malfunc-
tion of the cooling system and causes an appliance
breakdown.