BOMANN GSPE 7414 TI, Instruction Manual

Page: 9 / 24

9
WARNING:

The accessibility of the power plug must always
be ensured in order to disconnect the device from
the power supply in case of an emergency.

Make sure that the voltage supply matches the
specifications on the rating label (door frame) be-
fore connecting.

Connect the mains cable to a properly installed
and earthed wall outlet.

If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Prior Using for the first Time
Before using your dishwasher for the first time:
A. Filling salt into the salt container (water softener)
B. Fill the rinse aid dispenser
C. Fill in detergent
CAUTION:

Use only salt, rinse aid and detergent for dish-
washers. Other products may damage the appli-
ance.

Always consider the dosage and storage recom-
mendations on the sales packaging.
WARNING:
Keep salt, rinse aid and detergent out of reach for
children.
A. Filling salt into the salt container (water softener)
Water softener
The water hardness varies regionally. If hard water is
used in the dishwasher, deposits form on the dishes
and kitchen utensils. The appliance is equipped with
a water softener, that removes lime and minerals
from the water by using water softening in the salt
container. Your local water authority can advise you
on the hardness of the water in your area.
Adjusting the salt consumption
The salt consumption can be adjusted according to
your water hardness and therefore optimally regulat-
ed.

Turn on the appliance.

Press the Program selection button for more than
5 seconds, the setting mode is now activated for
approx. 60 seconds.

By repeatedly pressing the Program selection
button the water hardness can be selected:
H1->H2->H3->H4->H5->H6. The control lamps
indicate the selection (see below table).

The setting is automatically saved after a few
seconds; alternatively end the setup with the
Power button.
Water hardness Set-
ting
Control lamp
lights brightly
Salt cons.
/ cycle
°dH Mmol/l
0-5 0-0.94 H1 0 g
6-11 1.0-2.0 H2 9 g
12-17 2.1-3.0 H3*
12 g
18-22 3.1-4.0 H4 20 g
23-34 4.1-6.0 H5
30 g
35-55 6.1-9.8 H6
60 g
NOTE:
*Factory setting | °dH: German degree of hardness
Fill in the salt
CAUTION:

Only refill the salt container when the salt warning
lamp is lighting.

During filling the salt container, salt and water can
escape. Start a program immediately after you
have filled the container to prevent corrosion.

Remove the lower basket and unscrew the lid of
the salt container.