17
Turn the coarse filter counterclockwise and re-
move the whole filter system upwards.
Remove the coarse as well as the micro filter from
the main filter.
Remove leftover food and clean the filter under
running water. Use a soft brush for the coarse and
micro filter, if necessary.
Put the filter system properly in reverse order
together and reinstall in its provided position. Fix
the entire system, by tightening the filter unit
clockwise.
Cleaning the spray arms
Lime and impurities from the rinsing water can block
nozzles and bearings of the spray arms. Check the
outlet nozzles of the spray arms regularly for block-
ages.
Unscrew
the securing nut of
the upper spray and
pull off the arm downwards.
Pull off the lower spray arm upwards.
Clean the arms under running water; if neces-
sary, use a soft brush for the nozzles.
Insert the spray arms again until they click into
place and tighten the nut of the upper spray arm.
Maintenance of the dishwasher
CAUTION:
Never use spray cleaners to clean the door panel,
this may damage the door lock and electrical compo-
nents.
Clean the appliance outer surfaces and the door
sealing thoroughly with a soft, damp cloth. Use
only mild cleaning agent.
Use to remove stains inside the appliance a
dampened cloth with a little white vinegar or a
special detergent for dishwashers. If necessary,
fill detergent in and start the appliance without
dishware in the program with the highest rinse
temperature.
Dry the outer surfaces thoroughly before taking in
operation again.
Antifreeze protection
If the unit is out of operation and exposed to temper-
atures below zero, observe the following precautions:
Disconnect the mains plug.
Close the water supply and remove the inlet hose
from the water valve.
Drain the water from the inlet hose and the water
valve.
Reconnect the inlet hose to the water valve.
Turn off the lid of the salt container and take off
the filter system. Remove the remaining water in
the sump with an absorbent sponge.
Troubleshooting
Before you contact an authorized specialist
Problem
Possible cause / Action
Unit doesn’t
start
∙ Check the power supply. ∙ Is the
unit turned on and the door securely
closed? ∙ Is a program selected?
∙ Is the water supply properly con-
nected and the water supply opened?
Water is not
drained off
∙ Check the drain hose. ∙ Are the
filters or the kitchen sink clogged?
Noise
∙ Make sure that all dishes are se-
cured in the dishwasher. ∙ Place the
parts so that the spray arms can
rotate freely.
Foaming
Use only special dishwasher deter-
gent to avoid foaming. If this occurs,
open the door and let suds evapo-
rate. Add a bit of cold water to the
tub. Start a short rinse cycle to drain
out the water.
