BOMANN GB 388, Instruction Manual

Page: 15 / 24

15
Coolant Coolant Coolant Coolant
WAR WAR WAR WARNING NING NING NING::::
The coolant circuit of this appliance contains the
refrigerant Isobutane (R600a), a natural gas that is
flammable and of high environmental compatibility.
Make sure no parts of the coolant circuit get dam-
aged during transport and installation of the appli-
ance.
If the coolant circuit is damaged:
If the coolant circuit is damaged: If the coolant circuit is damaged:
If the coolant circuit is damaged:
•
avoid any open flames or ignition source,
•
disconnect the plug,
•
thoroughly air the room in which the appliance is
installed and
•
contact an authorized technician.
Unpacking the Appliance
Unpacking the Appliance Unpacking the Appliance
Unpacking the Appliance
•
Remove the appliance from its packaging.
•
Remove all packaging material, such as foils, filler
and cardboard packaging.
•
To prevent hazards, check the appliance for any
transport damage.
•
In case of damage, do not put the appliance into
operation. Contact your distributor.
NOTE NOTE NOTE NOTE::::
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
according to chapter “Cleaning and Maintenance”.
Appliance Appliance Appliance Appliance Equipment Equipment Equipment Equipment
Appliance overview Appliance overview Appliance overview Appliance overview
1111 Temperature
control
2222 Compressor
3333 Appliance door
4444 Fixed grid shelf
Delivery scope Delivery scope Delivery scope Delivery scope
Ice-cube tray
Installation
Installation Installation
Installation
Condition Condition Condition Conditions for the installation location s for the installation location s for the installation location s for the installation location
•
Good ventilation is required around the appliance,
in order to dissipate the heat properly and to
guarantee efficient cooling operation at low power
consumption. Sufficient clearance is necessary.
-
Gap to the back and to the side walls each
approx. 5 cm;
-
Place the appliance so that the appliance door
can open without being impeded.
•
Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to chapter “Technical Data” or to the rating label
located in the interior or on the rear side of the
appliance.
•
Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
•
Avoid the installation: Avoid the installation: Avoid the installation: Avoid the installation:
-
near heaters, next to a stove, direct sunlight or
any other heat sources;
-
at locations with high humidity (e.g. outdoors,
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
-
near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
-
Do not expose the appliance any weather.