Bomag BW 100 AD-5, Operating & Maintenance Instructions

Page: 154 / 212

3. Check the entire circumference of the V-
belt for damage and cracks.
4. Replace a damaged or cracked V-belt
Ä
Chapter 8.9.2 „Replacing the V-
belt“ on page 160 .
5. Check with thumb pressure whether the V-
belt can be depressed more than
7 to 9 mm (0.28 – 0.35 inch) between the
V-belt pulleys, retighten if necessary.
8.8.2.2 Tightening the V-belt
Protective equip-
ment:
n Working clothes
n Protective gloves
1. Loosen the tensioning screw (1) and the
screw (2) on the generator.
2. Press the generator towards the outside
using a lever, until the correct V-belt ten-
sion is reached.
3. Retighten clamping screw (1) and screw
(2).
8.8.3 Check the air intake lines
Protective equip-
ment:
n Working clothes
n
Protective gloves
1. Park the machine in secured condition
Ä
Chapter 6.7 „Parking the machine in
secured condition“ on page 113 .
2. Allow the engine to cool down.
3. Check the condition and tight fit of all air
intake lines and hose clamps.
4. If fuel lines or hose clamps are found to be
damaged, the corresponding parts must be
immediately replaced.
Fig. 123
Fig. 124
Maintenance – Every 250 operating hours
BW 100 AD-5 154