Bolton Tools ZX45 PD, Operating Manual

Page: 8 / 23

8
(3)If the gears are not engaged, remove the arbor bolt cover. Rotate the
spindle slightly to engage the gears, and then replace the arbor bolt
cover.
(4)Recheck the lever setting, and then turn the power on.
lever
RPM
Ⅰ-L Ⅰ-M Ⅰ-H Ⅱ-L Ⅱ-M Ⅱ-H
50HZ 80 145 260 375 710 1250
60HZ 95 175 310 450 850 1500
7.Installing and changing tools
WARNING: BE SURE THE POWER IS TURNED OFF AND THE MACHINE
UNPLUGGED BEFORE INSTALLING OR CHANGING TOOL BITS.
(1)Removing face mill or drill chuck arbor.
Loosen the arbor bolt at the top of the spindle shaft approximately
2 turn with a wrench. Rap the top of the arbor bolt with a mallet. After
taper has been broken loose, holding chuck arbor on a hand and turn
the arbor bolt with the other hand.
(2)To install face mill or cutter arbor
Insert cutter and cutter arbor into the taper of spindle. Tighten arbor
bolt securely, but do not overtighten.
(3)Removing taper drills
(a) Turn down the arbor bolt and insert the taper drill into the spindle
shaft.
(b) Turn down the rack sleeve until the oblong hole in the rack sleeve
appears, lock the rack sleeve, insert wedge though holes and strike
lightly with a mallet, this will force the taper drill out.
8. Ordering replacement parts
Complete parts list is attached, if parts are needed, contact your local
distributor.
9. Additional tools and accessories you will find helping
Each machine is equipped with a M.T.3 or R8; contact your local
distributor or a main cutting tool distributor to obtain any of these
accessories.
Taper drills, Reamers, End mills, Cutter, Arbor, Taps, Collets, Adapters
and sleeves
10. Specification of the T-slot
Please refer to figure. Purchase or make T-bolts and other table
top fixtures to these dimensions.