C H A P T E R 2 - I N S T A L L A T I O N
6
EFM-100 Display Software Installation
Insert the provided EFM-100 Software CD into your CD-ROM drive. The setup program
should start automatically. If the setup program does not start automatically you can start
it manually by clicking on
Start…Run…,
type
d:setup.exe
then click OK.
Once the software is installed you can run the EFM-100 display software by clicking on
Start…All Programs...Boltek…EFM-100 Electric Field Monitor
.
Instructions for installing USB Serial Adapter Driver Software
1)
Plug the USB adapter cable into the computer’s USB port.
2)
The “Welcome to the Found New Hardware Wizard” should appear. If it doesn’t
go to step 8.
3)
Ensure that the provided USB driver CD has been inserted into your CD-ROM
drive.
4)
Select the option: “Install the software automatically (Recommended).”
5)
Press “Next”
6)
Windows should find the “Prolific USB-to-Serial Com Port” driver.
7)
Press “Finish” when prompted by Windows to complete the installation.
If the “Found New Hardware Wizard” did not appear in step 2
Open Device Manager by doing the following:
a) Click on “Start” and then “Control Panel.”
b) Switch to Classic View (if in Category View).
c) Double click on “System.”
d) Select the Hardware tab.
e) Press the “Device Manager” button.
Under “Port (COM & LPT),” look for a USB Device entry with a yellow exclamation point
by it.
Right click on the USB Device and select “Update Driver”
This should bring up the “Welcome to the Hardware Update Wizard.”
Ensure the product driver CD (provided) is inserted in your CD-ROM drive.
Select the option: “Install the software automatically (Recommended).”
Press “Next.” Now begin at step 5 above and continue.
Hardware Installation
The EFM-100 field mill mounts on a ¾” NPT (National Pipe Thread) threaded pipe (Note
that ¾” NPT pipe measures 1” outside diameter)
A short length of ¾” NPT threaded pipe and a ¾” NPT mounting flange are provided for
mounting the field mill on a horizontal surface. Longer lengths of threaded pipe are
available at your local hardware store. Antenna mounting tripods are available at your local
Summary of Contents for EFM-100
Page 22: ...C H A P T E R 2 I N S T A L L A T I O N 16 Figure 16 Field Mill Grounding Detail ...
Page 32: ......
Page 40: ......
Page 44: ......
