bolid SIGNAL-20M, User Manual

Page: 84 / 106

85
Table 1.4.6.16 Buzzer operation modes (continued)
1.4.6.15 The panel allows mute the built-in buzzer.
To mute the buzzer, press the ______ button.
The muting of buzzer is indicated by the Muted LED (see Table 1.4.19 ).
However, the buzzer is automatically activated if the status of elements is changed (input, output,
power condition), if such changes require audible alarms.
To cancel muting, press the _____ button.
1.4.7 Panel Configuration Parameters
1.4.7.1 The panel has four groups of configuration parameters in its non-volatile memory:
–
System parameters;
–
Input parameters;
–
Output parameters;
–
Credential parameters.
1.4.7.2 The configuration parameters can be set using the ‘ Uprog.exe
’ program. The current
version of the program ‘ Uprog.exe
’ is available on the Bolid’s website: at
www.bolid.ru in the Software
section.
To configure the product, it must be connected to a computer with installed ‘ Uprog.exe
’
program through one of the interface converters (‘PI-GR’, ‘S2000-PI’, ‘S2000-USB’ or ‘USB-RS485’) in
accordance with Instruction manual for the used converter.
In addition, the S2000M panel of version 2.03 or higher can be used as an interface
converter, in accordance with the Operation Manual for the used panel.
Status of panel/element (input, output, power,
tamper, buttons)
Busser operation modes
1 2
Input states:
INPUT OPEN/SHOR CIRCUIT;
MAINS FAULURE;
EQUIPEMTN FAULT;
LEVEL ABOVE/BELOW LIMIT;
POWER/BATTERY FAULT;
TAMPER ALARM;
Output states:
OUTPUT OPEN/SHORT CIRCUIT;
Panel power fault
Single-tone intermittent
Other states
Off