CORPORACIÓN BOIA DOMENICO C.A.
5.2. Components Adjustment
14
Before adjusting any component, disconnect the band saw from the power source.
- If the blade goes out of the wheel or jumps, follow the next recommendations:
1. Adjust the upper wheel in the following manner:
a. If the blade goes out to the front: loosen the nut and the locknut, rotate the graduation
screw ¼ or half a turn clockwise, later turn the wheel and check if the blade is in the right
position, tighten the nut and the locknut.
b. If the blade jumps: loosen the nut and the locknut, rotate the graduation screw ¼ or half a
turn counterclockwise, later turn the wheel and check if the blade is in the right position,
tighten the nut and the locknut.
- If the blade continues presenting the same failure, follow the next steps:
2. Adjust the lower wheel in the following manner:
a. Loosen the nut on the upper side of the lower wheel support. Loosen the locknut that is
located immediately in behind the lower wheel support, rotate the nut clockwise a ¼ or
half a turn (if the blade goes out to the front), or counterclockwise (if the blade goes out
to the back).
b. Later tighten the nut and locknut of the front. Never loosen the lower nuts of the lower
wheel support to adjust.
- If the problem continues please contact the dealer immediately.
-
Difficulty cutting the meat:
It is possible that the blade is dirty, the wheels are dirty, the blade is
not centered or the blade is simply consumed. It is necessary to clean the blade and wheel, adjust
the blade or wheel, or change the blade. See section 2.1, 3.2, and 5.2. If the problem is worst
please contact the dealer.
-
Constant blade breaking:
The wheels and the blade are possibly dirty or filled with the products
pieces. Another possibility is that the wheels are consumed. Clean the wheels and blade or change
the wheels. See section 3.2 and contact the dealer if a new wheel is needed.