STITCH LINE
8 PERSON STRAIGHT WALL CABIN TENT
-
13 x 9
Item No. WMT-130976
Model No. 30160
• Empty contents of bag and confirm all parts are included
and undamaged.
NOTE:
Do this at home before you leave on your trip.
• Select a smooth level site and lay out your tent.
• Extend tent poles and place in position ready for installation.
• All poles are color coded for your convenience:
Labeled with orange stickers for four leg poles and two roof
poles. (Sticker color is matching with sleeve fabric color)
Labeled with gray stickers for 2 center leg poles and 1 center
roof pole. (Sticker color is matching with sleeve fabric color)
1
Setup Instructions:
Before you begin
Read all instructions thoroughly before beginning set up.
• Select a level site clear of rocks, branches, and other hard or sharp objects, to set up your tent.
WARNING:
Keep clear of overhead power lines.
• Do not set up your tent under trees because of potential lightning strikes or falling tree limbs in
inclement weather.
• For best results in windy conditions, position narrow end of tent into the wind.
• Secure with all stakes and guylines provided to prevent property damage or personal injury.
• Two people can easily setup this tent.
Parts List:
E (1)
Rainfly
w/6 S-hooks
I (10)
Stakes
H (1)
Stake Bag
J (1)
Carry Bag
G (1)
Pole Bag
F (1)
Divider
A (2)
Tent Roof Poles with
Orange Sticker
B (1)
Tent Center Roof Pole
with Gray Sticker
C (4)
Steel Leg Poles with
Orange Sticker
D (2)
Steel Center Leg Poles
with Gray Sticker
• Slide the Center Roof Pole B(1) with gray sticker through
middle roof sleeves; then secure by inserting both pole
ends into ribbed end of center Elbow Connectors.
(Details 1 & 2)
• Slide Tent Roof Poles A(2) with orange sticker into sleeves.
Insert one end of first pole into ribbed end of Elbow
Connector. Gently flex pole and insert other end of pole
into ribbed end of elbow connector at opposite corner.
Repeat for second Tent Roof Pole. Tie fabric straps at top
of tent around roof poles to secure.
(Details 1 & 2)
• At the back center of tent, place one end of a Center
Steel Leg Pole D(2) with gray sticker into the smooth
end of Elbow Connector, then secure the other end
of the leg pole onto the pin-rings at base of tent.
• At the front of tent, place one end of a Center Steel
Leg Pole D(2) with gray sticker into the smooth end
of Elbow Connector, then secure the other end of
the leg pole onto the pin-rings at base of tent.
• Place one end of a side Steel Leg Pole C(4) with orange
sticker into the smooth end of Elbow Connector, then secure
the other end into the pin-rings at base of tent. Repeat step
above for the remaining 3 poles.
(Detail 3)
• To stake out the tent, drive stakes through the pin-ring
assemblies on the tent base.
(Detail 4)
2
3
• Snap quick clips (attached to tent body) onto all tent poles to
shape the tent.
(Detail 5)
• Drape rainfly over tent. Connect S-hook on the rainfly into
the fabric loops at the 4 corners of tent.t. Connect S-hook
on the rainfly into the D-ring at the middle steel front and
back leg poles.
(Detail 6 & 7)
• Locate hook and loop fasteners on the underside
of the rainfly and secure around tent poles.
• To stabilize the tent, unroll the guylines attached
to the webbing loops on the rainfly. Make a
loop at the opposite end of the guyline
using the plastic slider and place the
loop over the tent stake. Drive the
stake into the ground to secure.
Adjust the plastic slider to tighten
the guyline. Repeat for each
guyline.
(Detail 8)
(continued on other side)
4
3
5
8
1
2
Ribbed
End
Smooth
End
Fabric
Straps
7
6
