32
SECTION II - PROGRAMMING
SYSTEM PROGRAMMING
System programming lets you set certain PCM options and tone features using the DTMF keys of a telephone. It also lets you program
paging zone groups and signaling zone groups.
All programming is accomplished through the TRUNK/P/P jack on the PCMTIM module regardless of the telephone interface used.
Note: To simplify initial programming, it is recommended that you use the Loop Start Trunk configuration with a single-line
2500-series telephone or your Butt Set connected to the TRUNK/P/P input.
You do not need to program the system to set the zones. The system is ready from the factory to access individual zones and
All-Call.
To program the PCM2000 system, follow these instructions:
1. Remove the switch lock on the PCMCPU module and place the PROGRAM/RUN switch to the PROGRAM position (down).
The green LED will illuminate.
2. Access the PCM2000 system (either use a single 2500-line telephone or butt set or dial the paging access number from the
telephone system).
3. You will hear 3 beep tones indicating access to the programming mode.
4. Dial the Feature Code for the option you wish to program. (See Feature Codes and Defaults list.)
Note: After you have entered a Feature Code (and any other data), you must press the [#] key to enter it into the system. If the
system accepts the code (and data), you will hear a short double beep confirming that the data has been stored in the system.
Continue with the next Feature Code immediately after the confirming double beep.
If the information is not accepted, you will hear a busy tone. In this case, you should hang-up, check the code and the data, then re-ac-
cess the system and try again.
5. Once you have finished programming, you must first hang-up the programming phone and then place the Program/Run switch in the
Run position. The green LED will go out. Replace the switch lock.
Remember to press the [#] key after you enter a Feature Code.
