5
Connections
70V & 25V Speaker Systems
Connect the 25V or 70V speaker loads to the corresponding terminals (25V or 70V) and the common terminal.
Make sure that the total wattage of all the connected speakers is less than 6 watts.
Note:
Do not use both the 25V and 70V terminals at the same time. Use only one type of speaker (25V or 70V) for all
speakers connected to the GA6A.
Link
The shorting link must be in place when using 25V or 70V speakers.
8
Ω
Ω
Speaker Systems
Low-impedance 8-ohm speakers can be connected to the GA6A.When using multiple speakers, the installer must
make sure that the total speaker load is not less than 8 ohms. Higher impedances than 8 ohms are safe to connect
to the GA6A, but the GA6A will not deliver its full output power to these higher impedance loads.
Connect the 8-ohm speaker load to the GND and 8-ohm terminals and remove the shorting link. 25V and 70V
outputs will not work in this configuration.
Note: If using multiple speakers, check for
proper phasing. See Section on Phasing.
Note: If using multiple speakers, check for
proper phasing. See Section on Phasing.
