10
Version 1 Oct 2009
Compressor
If the optional compressor is fitted, connect the compressed air line between the
laser and the extractor. Ensure that any water trap/ filter unit in use is situated
nearest to the laser (and not the extractor). The arrows (indicating air flow) on the
side of the water trap/filter should be pointing in the direction of the airflow (i.e. air
into the laser Unit).
Electrical supply connection
6. Check the integrity of the electrical power cable. Connect the power cable to an
isolated electrical supply. The mains socket outlet should be installed near the
equipment and be easily accessible. The cable run to the machine should be
arranged so as not to create a trip hazard.
Caution:
Check that the mains input at the isolated supply is the same as the voltage Supply
detail on the Serial Number label
(115 - 230v 50/60Hz)
before plugging the extractor
unit in.
General Safety Requirements
The mains socket outlet should be installed near the equipment and be easily
accessible.
Caution
Do not block or cover the cooling vents on the unit, as this severely restricts airflow
and may cause damage to the unit. (This may be located on the base of the unit).
Caution
This unit is over 18Kgs in weight and should only be lifted with suitable lifting
equipment.
Caution
If this equipment is used in a manner not specified by the manufacturer, the
protection provided by the equipment may be impaired.
Read all instructions in this manual before using this extractor.
Warning
Mains voltage. Dangerous voltages exist in this equipment.
Ensure all covers are fitted before operating this equipment.
The unit is now ready for use.
