Bodyworx JX300, Owner'S Manual

Page: 10 / 22

9
7. 7. MAINTENANCE MAINTENANCE
1. If the belt tends to move off from the center, stop the
treadmill. Take the L-shaped wrench and adjust the Hex
Screw in the Rear End Cap. For example, if the running
belt is moving towards the left side, tighten the left Hex
Screw about 1/4 turn (clockwise). If the running belt is
moving towards the right side, tighten the right Hex Screw
about 1/4 turn (clockwise). Turn on the treadmill after it
has been adjusted. If you find that the belt has not moved
to the proper position, please repeat the steps above. Don’t
use the treadmill until the running belt returns to the center
position.
(Ps.1.T his procedure is very important, if the belt is not in
the center, be sure to follow the above steps.)
(Ps.2 The position of running belt might not stay
precisely in the center with slightly towards the left
and right sides, and the situation varies with how
end-users use and the weight of end-users. No need
to adjust the belt if it doesn’t rub against the parts
aside.)
2. Depending on the usage of the product, please apply
SILICON on the board according to the below chart.
Use the L-shaped wrench to unscrew the bolt inside the
Rear Roller. Then pull the belt up and daub some
SILICON to the center of the board. After that, adjust
the belt to the center of the deck, followed by tightening
the screw to the original set.
(Ps. When the belt is sliding, please follow the above
method to lubricate the running belt.)
KGS/LBS Speed Interval
6KM/hr Below ear 1 y
6~12KM/hr 6 m onths
KGS
12KM/hr Above month 3 s
4mile/hr Below ear 1 y
4~8mile/hr 6 m onths
LBS
8mile/hr Above month3s
Note: This maintenance is intended for
household use.
If used for business, it is suggested to
examine the product every other month.