TO LUBRICATE THE DECK:
1.
Stop running belt so that the seam is located on top and in the center of the deck.
2.
Insert nozzle into spray head of lubricant can.
3.
Lift running belt.
4.
Position nozzle between the belt and the board approximately 200mm (8” ) from the
front of the treadmill.
5.
Apply the silicon from the front to the rear of the treadmill on each side of the
treadmill. Try to reach the spray as far into the center of the running deck as possible.
The spray time should be approximately four seconds for each side.
6. Spread the silicon by running the treadmill at 1 Km/H and step gently on the belt from
left to right. Do that for a few minutes and allow the silicon to soak into the belt.
CAUTION!
Over tightening of the belt will severely shorten the life of the belt and may cause further
damage to other components.
NOTE:
A well lubricated deck will ensure longevity of your treadmill in addition to providing you with
the optimal performance.
DANGER!
To reduce the risk of electrical shock, always unplug the treadmill from the electrical outlet
immediately after use and before cleaning.
Owner’s Manual 22
