STEP 3
LEG PRESS CABLE (243)
bolt end
metal ball end
-7-
1. Screw the threaded end (approximately half way) of the Leg Press Cable
(243) into the Single Pulley Block (27) as shown in Fig. 1.
2. Route the cable up and over the right side pulley in the Top Frame (5) as
shown in Fig. 2. Mount the pulley using one 3/8" X 2-3/4" Hex Bolt (89) and
one 3/8" Nylon Nut (107).
3. Continue to route the cable down to the pulley on the Base Frame (1) as
shown in Fig. 3. Mount the pulley using one 3/8" X 1-3/4" Bolt (91) and one
3/8" Nut (107).
4. Then route the cable up to the lower pulley in the Adjustable Pulley Block (25)
as shown in figure 4. Attach the pulley to the second hole from bottom. The
multiple holes are for cable adjustment. When cabling is complete, this pulley
can be moved upward to take up slack, or downward to gain length.
5. Continue to route the cable down to the pulley on the Base Frame (1) just
behind the weight stack, as shown in Fig. 5. Mount the pulley using one 3/8"
X 1-3/4" Bolt (91) and one 3/8" Nut (107).
6. Continue to route the cable underneath the weight stack and around the
horizontally mounted pulley on the Leg Press Main Frame (202). Mount the
pulley using one 3/8" X 1-3/4" Bolt (233) and one 3/8" Nut (241) as shown in
Fig. 6.
7. Continue to route the cable through the slot in Leg Press Main Frame (202),
and under and around (exiting on the top) the lowest pulley on the Rear Leg
Press Support (208) as shown in Fig. 7, Step 1. Mount the pulley using one
3/8" X 1-3/4" Bolt (233) and one 3/8" Nut (241).
8. Then route the cable under and around (exiting on the top) the right side (as if
sitting on seat) pulley mounted in Leg Press Main Frame (202) as shown in
Fig 7. Mount two pulleys here using one 3/8" X 2-3/4" Hex Bolt (232) and one
3/8" Nylon Nuts (241).
9. Route the cable in the same manner under and around the uppermost pulley
mounted on the Rear Leg Press Support (208) as shown in Fig. 7, Step 2.
Mount the pulley using one 3/8" X 1-3/4" Bolt (233) and one 3/8" Nut (241).
10. Route the cable in the same manner under and around the left side (as if
sitting on seat) pulley mounted in Leg Press Main Frame (202) as shown in
Fig 7.
11. Hook the ball end of the cable into the receptor on the Rear Leg Press
Support (208) as shown in Fig. 8.
Hint: When viewed from the side, the Leg Press Cable should be a series
of "loops". There should not be any "X's".
