BodyCraft Family XPress Pro, Assembly And Operating Instructions Manual

Page: 20 / 56

20
X2
Step 3: Assembly of the Seats Part 1
1. Assemble the front seat frame (18) to the front upright (4) with two bolts (128), four washers
(147) and two nuts (154).
2. Assemble the front seat frame (18) to the base frame (1) with one bolt (126), two washers (147)
and one nut (154).
3. Attach the leg extension arm (20) to the front seat frame (18) by inserting the leg extension
axle (39).
4. Fasten the leg extension axle (39) using two washers (148), two spring washers (150) and two
set screws (137).
5. Attach the plug (64) to the front of seat frame (18) and plug (66) to the top and bottom of leg
extension arm (20).
L
NOTICE
Make sure that the leg extension arm pivots freely.
6. Use the L Pin (81) to lock the leg extension arm (20).
7. Insert tube (31) into the front seat adjuster (19).
L
NOTICE
Use window cleaner or water for better sliding of roller pads onto tubes.
8. Moisten foam pads with foam pad covers (103 & 88) and slide it onto each end of tube (31).
L
NOTICE
It is recommended to use a rubber mallet.
9. Assemble two plastic covers (66) to both foam pads with foam pad covers (103 & 88) and
secure the pads with two washers (69) by using two screws (157) and two washers (173).
10. Lock tube (31) into place with pre-assembled set screw.
11. Assemble the seat pad (105) to the front seat adjuster (19) with two washers (147) and two
bolts (133).
12. Attach the plug (68) to the front seat adjuster (19).
13. Insert the front seat adjuster (19) into the front seat frame (18) and secure with one spring
(175) and lock with locking spring knob (79).
14. Assemble the seat back adjuster (23) to front upright (4) with one bolt (128) and one nut (154).
It may be necessary to tighten this bolt, then loosen just enough to let the seat back adjuster
(23) pivot freely.
L
NOTICE
The longer pop pin (77) should seat in the adjustment holes in the seat back adjuster (23).
15. Slide two metal hinges (24) onto the axle on top of the seat back adjuster (23).
16. Assemble the back pad (104) to the metal hinges (24) with four washers (147) and four bolts
(134).
17. Insert tube (31) into the leg extension arm (20).
L
NOTICE
Use window cleaner or water for better sliding of roller pads onto tubes.