background image

4 ft-lbs

(+/- 1 lbs)

4 ft-lbs

(+/- 1 lbs)

 Product Assembly

Please Hand Tighten All Bolts Until end of STEP 2

S

TEP 1a: Main Frame

Attach Rear Stabilizer (4) to Main 

Frame (1) using two Hex Bolts (14), 

four Flat Washers (10) and two Thick 

Nylon Nuts (12). 

1.    Attach LEG WEIGHT HOLDER(112) onto 
ADJUST TUBE(111), using HEX HEAD
BOLT(151), two 1/2" WASHER(153) and NYLON 
NUT(152).
2.    Insert FOAM ROLLER HOLDER(113) into the 
ADJUST TUBE(111) and LEG WEIGHT
HOLDER(112).
3.    Slide FOAM ROLLER(131) onto each side of 
FOAM ROLLER HOLDER(131).
4.    Attach END PLUGS(123) to FOAM ROLLER 
HOLDER(113) and attach 50 SQ. END
PLUG(122) to ends of LEG WEIGHT HOLDER(112).
5.    Slide RUBBER BUMPER(125) onto WEIGHT 
HOLDER(112). The SPRING CLIP(142)
is used to hold weight plates on WEIGHT 
HOLDER(122).
6.    L PIN(143) is used to lock LEG WEIGHT 
HOLDER(112).

S

TEP 2a: Install Foam Rollers

Slide END CAP, LARGER (5) then the FOAM 

ROLLER (4) onto each side of FOAM ROLLER 

HOLDER (3), one bar post at a time. 

NOTE: 

Confirm centered with equal distance on both 

Rt & Lt Sides.  

S

TEP 2b: Secure Foam Rollers

Then slide a HEX RECESSED HEAD 

BOLT, 5/16" x 1-1/4" (10)  through the 

END CAP, SMALLER (6) and the BIG 

WASHER, φ8 (13).  

Then secure by tightening the HEX 

RECESSED HEAD BOLT, 5/16" x 1-1/4" 

(10) to the FOAM ROLLER HOLDER (3) 

per side. Repeat to the other FOAM 

ROLLER HOLDERS.

S

TEP 2c:  Accessories

Attach RUBBER CUSHION (20), SPRING 

CLIP (8) and RING PIN (9).

TIP:

 

Recommended Tools

7/32 Allen Wrenches x 2ea.

S

TEP 2d:  “Torque Time”

Tighten STEP 2a & 2b, HEX RECESSED HEAD BOLTS 

(10) at this time to the Recommended Torque Specs of 

4 ft-lbs (+/-1 lb).

3

4 ft-lbs

(+/- 1 lbs)

Reviews: