Thank you for purchasing the Bodycraft
Flat / incline Bench
.
If You have any questions, please call your local BodyCraft dealer
or call our customer service department at 800-990-5556.
Do not tighten bolts until instructed.
1. Attach END CAP (10) to the FRONT STABILIZER (2) and REAR STABILIZER (3).
Attach FRONT STABILIZER (2) and REAR STABILIZER (3) to the MAIN FRAME (1)
using four 1/2" X 2-3/4" HEX BOLTS (21), eight 1/2" WASHERS (24) and four 1/2"
NYLON NUTS (26).
2. Attach HANDLE (7) to MAIN FRAME (1), using two 1/2" X 2-3/4" HEX BOLTS (21),
four 1/2" WASHERS (24) and two 1/2" NYLON NUTS (26).
3. Attach SEAT ADJUSTER (5) and BACK SUPPORT (4) to the MAIN FRAME (1), using
two 1/2" X 5" HEX BOLTS (18) and two 1/2" NYLON NUTS (26).
4. Attach pre-assembled BACK ADJUSTER (6) to BACK SUPPORT (4), using two
BUSHINGS (16), one 1/2" X 4-1/4" HEX BOLT (19), two 1/2" WASHERS (24), and one
1/2" NYLON NUTS (26). Tighten 1/2" X 6" HEX BOLT (29) and loosen approximately
1/2 turn to allow the BACK ADJUSTER (6) to swing freely.
5. Attach SEAT PAD (13) to SEAT ADJUSTER (5) and BACK PAD (12) to BACK
SUPPORT (4), using four 3/8" X 2-3/4" HEX BOLTS (22), four 3/8" WASHERS (25).
Attach END PLUG (11) to the SEAT ADJUSTER (5) and BACK SUPPORT (4).
Please ensure all parts attached and tighten bolts.
3
ASSEMBLY INSTRUCTION
