BodyCraft F438 RFT, Owner'S Manual

Page: 14 / 32

If you have 19 Weight Plates, DO NOT install the
two Stack Spacers (24), See figure 2 & 3.
IMPORTANT
1. Insert the four Plastic Guide Rod Holders (248) and four Rubber Cushions (247)
to the Connector Rear Stabilizer (201), and slide the Guide Rod (204) into it.
Before beginning Step 2, please read the following and
refer to Figures 2 and 3 on the next page .
- If you have 14 Weight Plates (222) per stack, install the
Stack Spacers (220) onto each of the Guide Rods (205). Fig. 2
14 piece weight plates & top plate = TOTAL 150 lbs stack.
- If you have 19 Weight Plates (222) per stack, DISCARD the
Stack Spacers (220), see Fig. 3.
19 piece weight plates & top plate = TOTAL 200 lbs stack.
2 . TWO PEOPLE ARE REQUIRED TO ASSEMBLE THIS STEP. With the guide
rods angled slightly (as shown in fig. 1), slide the Weight Plates (222) one at a
time onto the Guide Rods (204), making sure to orient the selector holes toward
the front. Attach the Top Plate (221) to the Selector Rod (223) using the Top Plate
Bolt (258). Tighten the Top Plate Bolt (258) using a hex key. Slide the Top Plate
into the guide Rods. Make sure the Selector Rod (223) goes through the center
holes of the Weight Plates (222).
3. Attach Top Plate Guide Rod Holder (210) to the Guide Rods (204) and secure with
two 5/16” X 5/8” Hex Socket Dome Bolts (260). Tighten the two 5/16” X 1/4”
Inner Hex Screws (263) to the Guide Rods (204). Use 3/8” X 5/8” Hex Socket
Dome Bolt (259) to tight Stopper (246) and the Top Plate Guide Rod Holder
(210).
P
RODUCT
A
SSEMBLY-
F438 - S
TEP
# 6
200 lb
Stacks
150 lb
Stacks
13