15
S T E P
3
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware first in this step. Wrench tighten ALL hardware at the end of
STEP 3E. Some components may be pre-assembled. Nylon lock nuts will not fully screw
onto bolts, they must be wrench tighten to fully go on.
3A.
Attach Foot Plate Support Frames
(F)
to Lower Crossmember
(A)
using:
4 - (#1) M12x80mm Hex Head Bolt
8 - (#5) M12 Flat Washer
4 - (#8) M12 Nylon Lock Nut
2 - (L) Bracket
Note: Please make sure the side of Foot Plate Support Frame (F) that does not
have the weld seam faces up.
3B.
Attach Foot Plate Support Frames
(F)
to Center Frame
(D)
using:
2 - (#9) M12x105mm Hex Head Bolt
4 - (#5) M12 Flat Washer
2 - (#8) M12 Nylon Lock Nut
3C.
Stick Two Foam Tapes
(#14)
on
Foot Plate Support Frames
(F)
as
shown on STEP 3 Drawing.
3D.
Stick Two Foam Tapes
(#14)
on
Lower Crossmember
(A)
as
shown on STEP 3 Drawing.
3E.
Attach Foot Plate
(G)
to Lower Crossmember
(A)
using:
2 - (#2) M12x70mm Flat Head Cap Screw
2 - (#5) M12 Flat Washer
2 - (#8) M12 Nylon Lock Nut
Summary of Contents for SOFB250
