Body Solid Powerline PPR-200X, Owner'S Manual, Page: 10 / 18

PPR-200X
STEP 1
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware in this step. DO NOT wrench tighten
until the last step. some components may be pre-assembled.
nylon lock nuts will not fully screw onto bolts, must wrench tighten.
Note: in these instructions left, right, top, bottom,
front, and rear are referenced from your back to the
machine. Make sure all rack frames (A) are facing the
same way like the picture to the right shows.
1A. attach right base support (I) to two rack frames (A)
using:
4 - (#2) M12X70mm hex head bolt
4 - (#6) M12 washer
4 - (#5) M12 nylon lock nut
1B. attach left base support (H) to two rack frames (A)
using:
4 - (#2) M12X70mm hex head bolt
4 - (#6) M12 washer
4 - (#5) M12 nylon lock nut
1C. insert end caps onto both ends of right base
support (I) and left base support (H) using:
4 - (#8) 50X50mm foot cap
1D. insert rubber dounts onto center of right base
support (I) and left base support (H) using:
2 - (#10) 50X50mm c leveler
10